Meyer V-MAX 3954 Operators Spécifications télécharger pdf (Page 23)

Model V-Force —23—

COVER

LUBRICATION & ADJUSTMENT FOR 3RD AUGER

WEEKLY LUBRICATION (every 25-30 loads)

)

Grease (1) bearing supporting the front shaft of

the 3rd auger assembly. This bearing is grease line fit-

ted to the spreader front, bearing back plate. The zerk

is accessible by opening the front steel shielding

cover.

SEASONAL LUBRICATION

Maintain oil level in the (1) oil bath enclosure at

the top, check plug line level. Check regularly for any

observable leakage. If oil leakage is excessive, repair

with silicone. Use #80-90 wt. gear lube oil

or an equiv

alent. Lighter weight gear lube oil may be used in tem

peratures less than 20°F. Change oil in the oil bath

enclosure after the first season of use and regu

larly thereafter. (2.5 gallon capacity) Condensation

can occur. Drain out water (bottom plug) as

needed.

Remove lower plug for draining purposes.

Remove reservoir cover or level plug for filling pur

pose. (SEAL COVER TIGHT WITH SILICONE

WHEN RE-INSTALLING.)

ADJUSTMENTS

The 3rd auger drive roller chain (large LH top re-

duction sprocket weldment to the 3rd auger) enclosed

in the oil bath is automatically tensioned by a spring

loaded idler/slide pipe. The tensioning, extension

spring should extend 3/4"

from its neutral 4" total

length.

Manual adjustment for the automatic tensioning idler

assembly is located at the RF, top of the oil bath en

closure just under the cover.

WARNING: DISCONNECT PTO DRIVE SHAFT AND HYDRAULIC HOSES (RELIEVE HYDRAULIC

PRESSURE) BEFORE CLEANING, ADJUSTING, LUBRICATING OR SERVICING THIS MACHINE. FAILURE

TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OF DEATH.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Pas de commentaire

Meyer V-MAX 3954 Operators Spécifications Page 23